Heating & Boilers · North Yorkshire

Cost of Air Source Heat Pump Installation in Redcar (2026)

Redcar quotes for air source heat pump installation are landing between £6,560 and £13,120 per system installed at the moment. Most jobs take 3–7 days. The three things that move the price most around North Yorkshire are heat pump size (kw output) for the property; whether a hot water cylinder is included; radiator upgrades needed for lower flow temperatures.

Typical cost in Redcar -18%
Low £6,560
Typical £9,840
High £13,120
Typical price per system installed Last updated 22 April 2026
  • Gas Safe Registered engineers only
  • OFTEC For oil-fired appliances
  • MCS Heat-pump certification
  • HETAS Solid fuel & biomass

About air source heat pump installation in Redcar

Redcar is a small town of around 36,000 in North Yorkshire. The housing is mostly red-brick Victorian terraces, stone-built millworker housing and post-war semi-detached estates typical of Northern industrial towns. That matters: older properties usually mean more pipework, rewiring and retrofit surprises, while newer builds in districts like TS10 tend to be quicker jobs with standardised fittings. Local trade prices sit below the UK average. Lower contractor overheads and shorter distances across North Yorkshire do most of the work.

Straight up, the North East is usually the cheapest region for trade work. Gas Safe engineers and electricians often quote 10 to 15 percent under the UK average. Newcastle, Durham and Middlesbrough are well served; rural Northumberland jobs tend to go to a regional firm rather than a one-van outfit.

Heating is a regulated trade. Gas Safe for anything gas, OFTEC for oil, HETAS for wood burners and stoves, MCS for heat pumps. The bulk of the price is the engineer's time, roughly £300 to £500 a day in 2025, plus the appliance. A summer quote on the same job is usually 10 to 15 percent less than a winter emergency one, so don't leave an ageing boiler until October.

Air Source Heat Pump Installation cost breakdown in Redcar

Basic £6,560 – £9,020

7kW unit for a well-insulated 2–3 bed with suitable radiators

Standard £9,020 – £11,480

11kW unit, new cylinder, 3–4 radiator upgrades

Complex £11,480 – £16,400

16kW unit, large property, full emitter upgrade and fabric works

What affects the price of air source heat pump installation in Redcar?

  • Heat pump size (kW output) for the property
  • Whether a hot water cylinder is included
  • Radiator upgrades needed for lower flow temperatures
  • MCS-certified installer rates
  • Boiler Upgrade Scheme grant eligibility (£7,500 off)
  • Outdoor unit siting and pipework runs

Redcar vs the UK average

Redcar sits in the heating & boilers market at a cost multiplier of 0.82× the UK national average. That puts Redcar air source heat pump installation prices at £6,560–£13,120 versus the UK average of £8,000–£16,000 per system installed.

Redcar vs UK national average — per system installed Redcar £6,560 £13,120 UK average £8,000 £16,000
Typical price range, per system installed

Air Source Heat Pump Installation cost calculator — Redcar

Estimated cost in Redcar
£9,470 – £12,055
per system installed

Estimate based on live 2025 UK trade pricing. Always get 3 written quotes before committing.

Get 3 free quotes from local air source heat pump installation specialists in Redcar

Compare prices from vetted, trade-body-certified professionals near Redcar (TS10). No obligation, takes about 2 minutes.

Get my free quotes
  • No obligation
  • Takes 2 minutes
  • Vetted tradespeople
  • Insurance-backed

What's typically included in a air source heat pump installation quote

  • MCS certification (required for BUS grant)
  • Supply and install of outdoor and indoor units
  • Hot water cylinder (where specified)
  • Controls and commissioning
  • DNO notification for electrical load

Frequently asked questions

How much does air source heat pump installation cost in Redcar?

Budget £6,560 to £13,120 per system installed for air source heat pump installation in Redcar. Prices here are around 18% cheaper than the UK average. What moves a quote inside that range is mostly heating contractor day rates in North Yorkshire and the specific material list for your job.

How long does air source heat pump installation take in Redcar?

A straightforward air source heat pump installation job in Redcar runs to 3–7 days. You can lose days to things outside the contractor's control — parts on backorder, awkward access, or a firm slotting your job around existing bookings. Ask for a start date and expected finish up front.

What's included in the price of air source heat pump installation in Redcar?

A proper air source heat pump installation quote in Redcar should cover: MCS certification (required for BUS grant); Supply and install of outdoor and indoor units; Hot water cylinder (where specified); Controls and commissioning; DNO notification for electrical load. If any of those aren't itemised on your quote, push back and ask. A written guarantee with a clear warranty period is reasonable to expect on this kind of work.

Is air source heat pump installation cheaper in Redcar than the UK average?

Air Source Heat Pump Installation in Redcar runs around 18% cheaper than the UK average. The UK-wide benchmark for this job is £8,000 to £16,000 per system installed; Redcar quotes tend to land between £6,560 and £13,120. Handy to know what the average actually looks like before you price round.

Do I need planning permission for air source heat pump installation in Redcar?

Most installations fall under Permitted Development, but listed buildings and conservation areas may require planning consent. If the property sits in a conservation area or is listed, ring North Yorkshire Council before you book anything in. It's a free call and saves a world of grief later.